A2 is a coarsed particled refractory and iron stained ball clay with enough bentonite to significantly slow drying and increase drying shrinkage. It is heavily contaminated with ironstone concretions, when pulverized in our equipment these break down into particulates many of which cause specking in firing (very pronounced reduction).
Plainsman A1 stockpile. The ironstone concretions are clearly visible around the bottom edges. This is the top-most layer of mined, many fossils found in the area of the quarry are from this layer.
Drying shrinkage is around 10%. Water needed to prepare pottery stiffness is about 27%, far higher than a typical stoneware or fireclay. The 42 mesh ground material has a very coarse texture. It would thus be normal for this be added to existing recipes to darken color, increase plasticity and add fired speckle.
The fired porosity is around 5% for cone 9, 10, 11 and 10R. While not a fireclay this is more refractory than a high temperature clay body. Since it has low water permeability heavier pieces made from A1 (or A1 containing bodies) must be completely dry before firing (force dried at 250F for an extended period).
A1 bowl by Zach Quin during 2023 Medalta residency. He processed the clay from lump to plastic form.
![]() |
Plainsman Clays 671 Industrial Ave. SE, Medicine Hat, Alberta T1A 3L5 Phone: 403-527-8535 FAX:403-527-7508 Email: tim.lerner@plainsmanclays.com |